Product Care and Cleaning
PRODUCT CARE GUIDE
Gray Hill Woodworking LLC
Preserve the beauty of your handcrafted piece for generations with these simple care recommendations. Each piece is created from carefully selected reclaimed wood and finished with food-safe, non-toxic coatings.
Functional Products
For items intended for food use or regular handling
Daily Care
Wash after each use with mild dish detergent
Clean gently using a damp sponge or soft cloth
Dry immediately with a soft cloth
Important: Never
Place in dishwasher
Allow to soak in water or cleaning products
Use abrasive pads or steel wool
Maintenance & Restoration
Should your piece begin to lose its luster, simply apply a fresh coating of Odie's Oil to re-seal the wood. (instructions below)
Decorative Products
For display pieces and occasional-use items
Daily Care
Dust regularly with a soft cloth or duster
Avoid all cleaning products and waxes
Maintenance & Restoration
In the unlikely event that the finish begins to fade, simply reapply a coating of Odie's Oil according to manufacturer directions.
Following these simple steps will keep your handcrafted piece looking beautiful for decades.
Odie’s Oil Instructions
I’m proud to be using Odesseus Cornwall’s Family of products. Although “Odie’s Oil” is the go-to product, any of the Odie’s line of products will give you the professional results you are looking for.
The Odie’s Finishes are true hard wax oils and are proudly made of 100% natural ingredients. Unlike other finishes, it takes just a few easy steps to ensure a brilliant and long-lasting finish for your project.
Recommend the Odie’s universal finish for general care of our products
Tools needed:
Use the non-woven pad to work the product into your project surface. The friction from the application helps drive the product to the surface. Remember: A little Odie’s goes a long way, so don’t overdo it!
After working the product into the surface with the pad, allow it to set for 10 minutes to 3 hours (depending on the product used and surface applied to). You can wait, but your buff/wipe off may be a bit tougher. Do not allow the product to set for more than 12 hours! This will require a re-application to re-activate the finish for a proper buff/wipe off.
After waiting for the product to set up, take a clean terry (100% cotton) cloth towel and proceed to BUFF/WIPE OFF ALL the product from your project surface. When your towel has loaded up with product, switch to a new clean terry cloth towel until the entire surface is buffed off clean and NO product REMAINS. If you can swipe a clean finger across the surface and make no mark you are done.
Cure time for Odie's Universal for general use is 24 hours and can be exposed to liquids within 3 to 5 days.
Additional coats of Odie’s products can be applied using these same easy steps above. We suggest waiting 24 hours in between coats.
For Epoxy/Resin projects we recommend using less oil than on wood - follow the same application process.
This page contains affiliate links, which means we may earn a commission if you make a purchase through those links at no additional cost to you. We only recommend products or services that we genuinely believe in and have personally used or researched. Your support through these affiliate links helps us continue to provide valuable content and resources for our customers.